Using outdoor rated switchboards or feeder pillars for EV Distribution removes the requirement for a substation or GRP enclosure.

If required our products can be close coupled to a standard oil filled transformer via a mono-block connection removing the need for cabling, saving both cost and installation time.

As we design and build in house we can accommodate a vast array of bespoke requirements within our pillars, such as:

• Fitting of clients CCTV / Communications / Scada equipment
• Surge protection
• Metering

Every switchboard for EV charging distribution is individually designed to suit our clients requirements including:

• Forms of separation: Form 2 to 4, type 1 to 7
• Ratings: 100A to 6300A
• Type tested assemblies (BS EN IEC 61439-2)
• Board access: Front and rear
• Cable entries: Top and bottom, entry or exit
• Electrical, mechanical interlocking
• Restricted, unrestricted earth fault
• Surge protection